#OUTSIDE BENCH FULL#

Overhand the front of the seat by 1-1/2″ and space the boards about 1/4″ – 1/2″ apart. The seat and back can now be installed with 2-1/2″ exterior wood screws as shown in the diagram below. Then secure with (4) 2-1/2″ exterior wood screws each. Before securing, use a straight edge to check the bottom of the legs to assure they are in the same plane (will sit flat on the ground when upright). 'outdoor wooden benches' VIFAH Atlantic Red Brown 5Ft Slatted Eucalyptus Wooden Garden Bench for 3 Seater in Entry Way 540 -63 164 00 439.99 Small Business 'white outdoor benches' Décor Therapy Outdoor Bench, White 337 -43 136 81 239.99 'small outdoor benches' Furinno FG181110-C Tioman Outdoor Backless Bench, Natural 641 -11 79 95 89. The 6″ measurement on the shorter leg should get the legs pretty close to the correct alignment. Note that the 19″ side of the short leg should be towards the back of the bench. Use the dimensions in the diagram above to mark the line that the shorter leg will fall on (as shown below). The legs are assembled with (4) 2-1/2″ exterior wood screws each, as shown below. Garden Bench Patio Bench Outdoor Park Bench with Armrests, Porch Bench Cast Iron Sturdy Steel Frame Furniture, 480BLS Bearing Capacity for Park Yard Deck.

Add some outdoor cushions for extra comfort and a decorative touch. TECSPACE Aluminum Outdoor Patio Bench Black,35.4 x 14.2X 15. Extra 10 off on staycation essentials with code: Staycation. Choose one with a backrest for added support, or go for a space-saving backless bench that tucks away under the table. Outsunny 50' 2-Seater Garden Bench, Patio Decorative Chair Metal Backyard Loveseat Outdoor Furniture for Yard, Lawn, Porch, Black. Using the diagram below, mark the line with a straight edge and cut the taper with a circular saw. Outdoor benches offer a versatile seat, whether you’re eating dinner or relaxing in the sun. Not only does it look nicer but it will be the correct angle of the back.

#OUTSIDE BENCH FULL#

Rather than leaving the longer leg a full 2×8, we need to cut a taper at the top of the back. To make the angled cut marks you can used a speed square, by pivoting the corner until the correct angle is aligned with the edge of the board, as shown below.

The angled cuts can be cut with either a miter saw or marked with a speed square and cut with a circular saw. The 2x8s should be cut down per the following diagram.

This is an easy yet sleek looking bench that can be built for around $30, in about 30 mins, and with only 3 tools (drill/driver, circular saw, and speed square).

Outside bench